Offering a Like New L.E. Wilson Cartridge Case Gage in 338 Winchester Magnum. Gage is rust free, in original box with instructions. Appears un-used as it is still in the grease wrapper.

· This is a two piece adjustable cylinder-type gage for checking fired and resized cartridge cases for cone-to-head and overall length

· Used to compare cartridges against the minimum SAAMI chamber dimensions

Instructions:

· Drop a fired case into the gage. Take a measurement on headspace. This can be done with either a depth micrometer or caliper (Depending on if the case is sitting high or low in the gage). If the case sticks out past maximum headspace the firearm probably has a larger than average chamber. The gage can still be used because it is being used to determine how much resizing is required.

· Now once the initial measurement is taken, slowly dial in the full length sizer until there is a 0.001 to 0.002 drop in headspace. This will give the measurement to resize the case just below the chambers headspace in the firearm being reloaded for, giving a more accurate shot and saving brass by not causing it to be overworked.

· Once the brass has been sized, set the brass in the gage and set the gage on a flat surface with the head side facing down. Now look across the top of the gage, this give the maximum and minimum for trim length.